CJ Appliance Repair(918) 992-4002

Dryer repair · Tulsa, OK

Dryer taking too long to dry?

One load, two cycles, and the jeans are still damp at the seams. Most of the time the trouble is air that can’t get out, not heat that won’t come on.

Repair ticketNo. 4002

My . It’s a in .

Or send it as a requestTexting? Add a photo of the model tag.

  • Colby answers his own phone
  • Most visits within 48 hours, often same day
  • Diagnostic fee waived when he does the repair
Text

Before you call

Try these first

Smell gas? Don’t touch any switches. Leave the house and call your gas company from outside. If the top of the dryer gets very hot or you smell scorching lint, stop using it until the vent is clear.

What usually causes it

Why clothes stay damp

01

A restricted vent Most common

Hot air carries the water out of the clothes, and it has to leave through the duct. Lint builds up along the run, at every bend and at the outside hood, and a crushed foil duct behind the machine chokes it further. The dryer still heats, so clothes come out hot and damp.

Colby checks the airflow from the drum to the hood and shows you where it’s blocked.

02

Clothes leaving the washer too wet Check the washer

If the washer isn’t spinning hard or draining fully, the dryer gets a load that’s soaking. Clothes that drip when you lift them out of the washer are the giveaway.

He repairs washers too, so he can check both machines and you don’t fix the wrong one.

03

A thermostat or the gas valve coils Heats, then quits

Some dryers heat for a few minutes and then stop, so the load sits in lukewarm air for most of the cycle. On gas dryers worn valve coils are the classic reason; on any dryer, a cycling thermostat that opens too early does the same.

He watches the heat through a full cycle and tests the thermostats and coils against their ratings.

04

The thermistor or the controls Electronic models

On dryers with a digital panel, a small sensor called a thermistor tells the control how hot the air is. When it reads wrong, the control turns the heat down or ends the cycle too soon.

Colby tests the thermistor’s reading and replaces it if it has drifted out of range.

Questions

Takes too long to dry: questions people ask

Q

My clothes come out hot but still damp. What does that mean?

AHeat without drying points to airflow: the moisture has nowhere to go. Damp and cool points the other way, to the heat source. That one detail tells Colby where to start.

Q

Is a slow dryer a fire risk?

AIt can be. Lint is what catches fire in a dryer, and a blocked vent is where lint piles up while the heat climbs. Treat long drying times as a reason to get the vent checked, not just an annoyance.

Q

Does the length of the vent matter?

AYes. Every foot of duct and every bend slows the air, which is why dryer manuals list a maximum vent length. Long runs, especially ones that go up through the roof, clog sooner and need cleaning more often.

Q

Do you charge to come out?

AYes. There’s a diagnostic fee for the visit, and if you have Colby do the repair, the diagnostic fee is waived.

Q

How soon can you come?

AMost appointments are within 48 hours, many within 24, and often the same day. Call or text and Colby will give you the soonest time he has.

Rather type it out?

Send Colby a request

Tell us what's wrong and how to reach you. Colby will call or text you back.

  • Calls and texts(918) 992-4002
  • Tulsa, Oklahomaand the towns around it
  • Texting?A photo of the model tag helps Colby know what he’s working on.
Repair requestCJ Appliance Repair

Tulsa · (918) 992-4002

Broken appliance? Call Colby.

Call (918) 992-4002